AI-powered OBD-II fault code diagnostic tool for UK drivers
P0137

P0137 O2 Sensor Circuit Low Voltage (Bank 1, Sensor 2)

P0137 indicates o2 sensor circuit low voltage (bank 1, sensor 2). Start with the sensor or circuit the code names, then rule out the air, fuel and mechanical faults that commonly mimic it before replacing parts.

Last updated 22 July 2026

AI-generated guidance for UK drivers. It is educational guidance for P0137, not a substitute for live data, workshop testing, or a final quote. Always confirm with a qualified mechanic.

How this content is made UK MOT guide DVSA MOT inspection manual
UK Repair Cost
£50–£250
MOT Risk
High risk of MOT failure
Safe to Drive?
Driveable short-term but fix before your MOT.

At a glance: P0137 for UK drivers

Fault family
Oxygen sensor and catalyst monitoring
Best first check
Confirm it is the downstream sensor (Bank 1 Sensor 2) and not the upstream one.
Typical garage risk
Replacing the sensor without checking for an exhaust leak and wiring faults. A leak ahead of the sensor or a damaged wire can set P0137 on a good sensor. If P0420 is also stored, sort out the sensor fault before assuming the catalyst has failed.

How to use this page

This page explains the code in plain English and gives indicative UK repair and MOT context. It does not confirm the exact failed part. Vehicle age, engine, related codes, live data, and workshop inspection can all change the final diagnosis and quote.

What does fault code P0137 mean?

P0137: Bank 1 downstream O2 sensor reading low — could be sensor fault or exhaust leak. Check wiring first (£50-£250). MOT fail risk. When this fault is detected, the ECU (Engine Control Unit) stores the code and usually illuminates the check engine light on the dashboard.

Before any parts are ordered: Confirm P0137 with a scan tool and check for related stored codes first.

Symptoms of fault code P0137

These are the most common symptoms UK drivers report when this code is active:

  • Check engine light on
  • Possible poor fuel economy
  • Failed MOT emissions
  • No drivability issues in most cases

Note that some vehicles show no drivability symptoms at all — the check engine light may be the only sign. This is why scanning the fault code is essential rather than guessing at the cause.

What causes P0137?

These are typical causes to check first:

  1. Faulty downstream O2 sensor (Bank 1 Sensor 2) — low voltage output
  2. Wiring short to ground
  3. Contaminated sensor element
  4. Exhaust leak affecting readings

It is important to diagnose the root cause before replacing parts. Many unnecessary and expensive repairs happen because the most expensive component is replaced first without proper testing. Always work through the diagnostic steps systematically.

How to fix P0137 — step by step

Work through these steps in order to avoid unnecessary parts replacement:

  1. Check downstream O2 sensor wiring for shorts or damage
  2. Test sensor voltage with live data
  3. Inspect exhaust for leaks near the sensor
  4. Replace the sensor if voltage is stuck low

After any repair, clear the fault code with an OBD-II scanner and carry out a test drive. If the code returns, continue to the next diagnostic step. For a personalised repair guide specific to your vehicle's make, model, year and engine, use our AI Diagnostic Report below.

UK vehicles commonly affected by P0137

These are examples of UK-market cars where garages frequently see this code:

  • Ford Focus/Mondeo
  • Vauxhall Astra/Vectra
  • Volkswagen Golf/Passat
  • BMW 3/5 Series

This code can appear on OBD-II compatible vehicles. OBD-II is standard on most UK petrol cars from 2001 and diesel cars from 2004, with many later-1990s vehicles also compatible. The models listed above are examples where owners and garages often encounter this fault, but they are not an exhaustive or ranked list.

DIY difficulty and cost guide

Difficulty: Easy to medium — sensor replacement is straightforward.

UK repair cost estimate: £50–£250 including parts and labour at average UK workshop rates (inc. VAT). Independent garages are typically 30–50% cheaper than main dealers. Always get at least two quotes.

Prevention: Use quality fuel and maintain exhaust system integrity.

Detailed analysis for P0137

What usually triggers P0137 on UK cars

P0137 is a low-voltage fault on the Bank 1 downstream oxygen sensor, the one after the catalytic converter. The ECU uses it to judge how well the catalyst is working, so the car usually drives normally but may fail an emissions test. A reading stuck low can come from the sensor itself, a short to ground in its wiring, or an exhaust leak ahead of it.

Checks that save money before replacing parts

  1. Confirm it is the downstream sensor (Bank 1 Sensor 2) and not the upstream one.
  2. Inspect the sensor wiring and connector for chafing, heat damage and shorts to ground.
  3. Look and listen for exhaust leaks between the engine and the sensor.
  4. Check on a scan tool whether the reading is stuck low or moves at all.

Common misdiagnosis to avoid

Replacing the sensor without checking for an exhaust leak and wiring faults. A leak ahead of the sensor or a damaged wire can set P0137 on a good sensor. If P0420 is also stored, sort out the sensor fault before assuming the catalyst has failed.

Questions to ask your garage about P0137

  • Is this the downstream (Bank 1 Sensor 2) sensor?
  • Was the exhaust checked for leaks before the sensor?
  • What does the live voltage show?
  • Was the wiring tested for a short to ground?

P0137 and the UK MOT test

Fault code P0137 is likely to cause an MOT failure. A stored code does not automatically fail an MOT, but if it keeps the malfunction indicator lamp (MIL / check engine light) on where MIL inspection applies, or affects emissions, it can cause a failure.

Even if the light is not currently on, if the fault is intermittent it could reappear during the test. Use our AI Diagnostic Report to understand the MOT risk specific to your vehicle and get advice on whether it is safe to proceed to your test.

Sources and references

Useful UK sources for further reading:

Repair cost estimates are indicative ranges for UK independent garages, based on typical UK labour rates and parts prices; your quote will vary by vehicle, location and garage. All content is for educational purposes and is not a substitute for professional mechanical diagnosis.

Get Your Full AI Diagnostic Report for P0137

Specific to your vehicle — year, make, model and engine.
Includes step-by-step repair guide, exact UK labour costs and MOT impact.

Get My Report for P0137 — £1.59 →
One-time payment No subscription Detailed report UK-specific advice

Frequently asked questions about P0137

What does P0137 mean in plain English?

P0137 indicates o2 sensor circuit low voltage (bank 1, sensor 2).

Will P0137 fail an MOT?

If this fault keeps the malfunction indicator lamp or another relevant warning light active, it can cause MOT problems in the UK. Confirm the root cause and clear the fault properly before test day rather than just erasing codes.

Can I keep driving with P0137?

Driveable short-term but fix before your MOT.

How much does it usually cost to fix P0137 in the UK?

Typical UK repair costs for P0137 range from £50–£250, depending on the underlying fault, your exact vehicle, and local labour rates.

What is the difference between P0137 and P0138?

Both relate to the Bank 1 downstream oxygen sensor circuit. P0137 is a low-voltage fault and P0138 is a high-voltage one, and the checks are similar.

Does P0137 mean the catalytic converter has failed?

No. P0137 points at the downstream sensor circuit or its reading. A failing catalyst more often sets P0420, so check the sensor, wiring and exhaust leaks first.

Related guides for P0137

Use these supporting pages to compare likely repair paths, warning-light behaviour, MOT risk, and the questions to ask before approving work.

O2 sensor fault codes guide UKWill an engine management light fail MOT?

Related and nearby OBD2 codes

Compare P0137 with closely related faults, nearby codes in the same family, and adjacent module or sensor faults that often need to be ruled out during diagnosis.

P0136
O2 Sensor Circuit Malfunction Bank 1 Sensor 2
P0138
O2 Sensor Circuit High Voltage Bank 1 Sensor …
P0135
Upstream O2 Sensor Heater Fault — Fuse, Wirin…
P0141
Downstream O2 Sensor Heater Fault — Underbody…
P0101
MAF Sensor Out of Range — Clean or Replace?
P0102
Mass Air Flow Circuit Low Input
P0103
Mass Air Flow Circuit High Input
P0113
IAT Sensor High Reading — Connector & Wiring …
P0115
Engine Coolant Temperature Circuit Malfunctio…
P0116
Engine Coolant Temperature Circuit Range/Perf…
P0117
Engine Coolant Temperature Circuit Low Input
P0118
Engine Coolant Temperature Circuit High Input

Last updated: 4 October 2026. AI-Diagnostics-Pro provides AI-generated information for educational purposes only. It is not a substitute for professional automotive advice. Always consult a qualified mechanic before carrying out vehicle repairs. Repair cost estimates are approximate and may vary by region and vehicle.